Fhamre
Super Member
Picked up a nice little CR66ll. Needed a little attention.
Looking at some great older posts I repaired a very stiff tuning shaft. Replaced the lights with LEDs.
I found the DC offset to be about -95mv /channel.
So I put a 1k trimmer in place of R407 and R408.That allowed me to get to 0mv easily.
So while I was patting myself on the back I noticed that I no longer had my lights. Was a bit of work to do a nice job putting them in. But I have since taken them out and checked each one,again. No luck.
I am getting 39V at L1,L2,L4. 6V at L3.
Any suggestions?
Looking at some great older posts I repaired a very stiff tuning shaft. Replaced the lights with LEDs.
I found the DC offset to be about -95mv /channel.
So I put a 1k trimmer in place of R407 and R408.That allowed me to get to 0mv easily.
So while I was patting myself on the back I noticed that I no longer had my lights. Was a bit of work to do a nice job putting them in. But I have since taken them out and checked each one,again. No luck.
I am getting 39V at L1,L2,L4. 6V at L3.
Any suggestions?