The last time I checked those were reading +44 and -44 I'll see if I can bring that voltage down when I get home.I'm at work at the moment but I'm guessing that the two pins marked -36 and +36 have something to do with it.
The last time I checked those were reading +44 and -44 I'll see if I can bring that voltage down when I get home.I'm at work at the moment but I'm guessing that the two pins marked -36 and +36 have something to do with it.
Measure the DC voltage on the base of TR802 referenced to chassis ground.I changed the trimmer
Got it -25vdc right on the money.Measure the DC voltage on the base of TR802 referenced to chassis ground.
Got it -25v right on the money.
I can but the schematic says -25vdcSee if you can adjust it to - 13 vdc with VR801.
Not on the schematic I'm looking at. What schematic are you using ?I can but the schematic says -25vdc
Download from hifiengine.comNot on the schematic I'm looking at. What schematic are you using ?
Same one I'm looking at.Download from hifiengine.com
The best I could it to is -12.50vdcSame one I'm looking at.
My eyes just ain't what they used to be.Ok I see it now with a magnifying glass -13v
Join the club..My eyes just ain't what they used to be.
Just found another problem.The meter lights weren't working so I ordered some new ones and now they work but they are producing a hum through the speakers there was no hum before I put the new light bulbs in.Join the club..
Look around for a possible broken black wire or a poor ground connection. Look at any boards you may have moved/removed replacing the lamps. Some boards have fasteners that connect the circuit board to chassis ground.And need to be very tight connections.The meter lights weren't working so I ordered some new ones and now they work but they are producing a hum through the speakers
I have some mje15032g do you think those will work?2SD234 ----
512-KSD526Y
Yes..Way overkill.I have some mje15032g do you think those will work?
No but while I'm in here I thought I should replace them because I noticed they got really hot.Give me your opinion should I order the ksd526 and wait two weeks or pop the mje15032s in there since I already have them?Do the D234's test bad ?