gopernoper
New Member
Hello everyone-
My name is Will. My friend recently got me into vinyl, and as such have been looking for new gear to use with my turntable (Technics SL-BD27). Anyways, I found a Sansui 8080DB that was in our cottage. I was very excited about it, as I had read they were excellent receivers. But of course, there are some issues with it. I know this has probably been asked many times on here, but I need to know how to get it working, and if I can't where can I get it repaired. Something to note- I am 16. I don't have deep pockets, more empty pockets.
Firstly, when the receiver is powered on, the Protection light flashes red continuously. It does not turn green or stop at any time. It is my understanding that it is required to check the driver board and replace some of the components. Where can I find the replacement parts/ how can I check these?
Second, I am not sure if the Dolby Board is good in this particular receiver, I cannot test as the protection light will not turn green. Is there a way to test it in its current condition? I am aware of the repair process, and would care to avoid undertaking it. I am not new to soldering, but I do not have the experience working with this sort of components/hardware. I do not have the proper tools to work on a soldering job like this. If repair is unavoidable, is there a replacement available?
Thanks for bearing with me.
My name is Will. My friend recently got me into vinyl, and as such have been looking for new gear to use with my turntable (Technics SL-BD27). Anyways, I found a Sansui 8080DB that was in our cottage. I was very excited about it, as I had read they were excellent receivers. But of course, there are some issues with it. I know this has probably been asked many times on here, but I need to know how to get it working, and if I can't where can I get it repaired. Something to note- I am 16. I don't have deep pockets, more empty pockets.
Firstly, when the receiver is powered on, the Protection light flashes red continuously. It does not turn green or stop at any time. It is my understanding that it is required to check the driver board and replace some of the components. Where can I find the replacement parts/ how can I check these?
Second, I am not sure if the Dolby Board is good in this particular receiver, I cannot test as the protection light will not turn green. Is there a way to test it in its current condition? I am aware of the repair process, and would care to avoid undertaking it. I am not new to soldering, but I do not have the experience working with this sort of components/hardware. I do not have the proper tools to work on a soldering job like this. If repair is unavoidable, is there a replacement available?
Thanks for bearing with me.