I got this amp and I replaced a few resistors that were wrong from someone else so both boards are correct and identical and the caps on the control boards too. One control board after turning on lights up the normal led and the clip led stays on and the output relay closes. It does this for either amp module it’s hooked to. The other control board after turning on lights up the normal led, the clip led goes off and the relay closes. Then after 30 seconds the relay starts to open and close constantly along with the clip led lighting up and off. It does this for either amp module it’s hooked to. I’m not sure what to look for to figure this out. Should I check all the output devices to see if any show bad, there’s 14 per module. The only thing I have is the circuit drawing from the JBL site.