PAUL Camden
Member
Ok, so I recently acquired a Pioneer spec 1 preamp, a spec 4 amp.
This is what I would like to do, I have 4 B & W speakers that are 8 ohm. I would like to run those parallel
on the spec 1 preamp a & b terminals. I also have a set of cerwins that are 4ohm that I like to hear once in a while LOUD. so I read the manual from pioneer on Bi amp connection so here's my question.
can I run the left-right speaker wires from the spec four to spec one Pre, connect 4 8 ohm speakers
to A & B on spec one pre amp, and... connect another amp, a mcintosh mc2500 and then connect the 4 ohm
cerwins to the amp? run both amps and all 6 speakers?
or would I have to run all speaker wires directly to the amps?
or what about using my sherwin hp2000 for the other amp, separating from its preamp??
This is what I would like to do, I have 4 B & W speakers that are 8 ohm. I would like to run those parallel
on the spec 1 preamp a & b terminals. I also have a set of cerwins that are 4ohm that I like to hear once in a while LOUD. so I read the manual from pioneer on Bi amp connection so here's my question.
can I run the left-right speaker wires from the spec four to spec one Pre, connect 4 8 ohm speakers
to A & B on spec one pre amp, and... connect another amp, a mcintosh mc2500 and then connect the 4 ohm
cerwins to the amp? run both amps and all 6 speakers?
or would I have to run all speaker wires directly to the amps?
or what about using my sherwin hp2000 for the other amp, separating from its preamp??