Robisme
Sansui Enthusiast
I am working on a KA-7100 that did not come out of protection. I tested the outputs, drivers, DC offset at the relay, and bias. All OK.
I decided to replace the power LED before I went any further, and when I connected the new one (I had it powered up) it came out of protection. Disconnected the LED and back into protect it went. Reconnected LED and out of protect again.
Installed the LED and it works fine. I don't have the schematic.
Rob
I decided to replace the power LED before I went any further, and when I connected the new one (I had it powered up) it came out of protection. Disconnected the LED and back into protect it went. Reconnected LED and out of protect again.
Installed the LED and it works fine. I don't have the schematic.
Rob