cwh
33
Hey gang, picked up a tossed out pair awhile back and I'm hoping to get them working. I've included a schematic that was drawn up the venerable Paul Carlson.
Goal is to not toast the new tubes/cause additional issues upon initial power up.
Visible issues:
Both amps have one burnt resistor. #1 EL 84 PIn 3 and #2 EL 34 Pin 5. Each have a 0.1uf bypass that show signs of heat.
Broken impedance switch, broken fuse holder, damaged filter cap, no tubes.
Where I'm at:
Replaced broken mechanical bits, main filter caps and resistors.
New Jim McShane tubes at the ready.
Thanks for any hand holding you may provide.
Goal is to not toast the new tubes/cause additional issues upon initial power up.
Visible issues:
Both amps have one burnt resistor. #1 EL 84 PIn 3 and #2 EL 34 Pin 5. Each have a 0.1uf bypass that show signs of heat.
Broken impedance switch, broken fuse holder, damaged filter cap, no tubes.
Where I'm at:
Replaced broken mechanical bits, main filter caps and resistors.
New Jim McShane tubes at the ready.
Thanks for any hand holding you may provide.
Last edited: