Bkphoto
Super Member
Not sure who you are asking. The QLS1's have 2 pair of binding posts that have a jumper between. You can pull the jumper which separates the Watkins from the others. Then you can split the signal from the preamp however you like. Active crossover or just y cord. Then just feed 1 amp to watkins, other amp to mids and highs. Just use the internal crossover in the speaker. I have an active so I will give it a try both ways.
hahahaha, i know that man.....
so you are using a splitter after your preamp...(this was the part i was asking about)
my point was you are sending the whole signal from each amp without the active crossover...(highs, mids, lows) to the watkins, then same thing to the upper part of the speaker...