Calling any and all Carver gurus,
There I was, just listening to some nice tunes with my Carver M500t and suddenly, burning smell, fuse blows, and silence…
Crack her open and r181 is toasted.
Nothing else looks affected (to the naked eye).
I’ve done a fair bit of repair/ recapping, etc. but...
Hi All,
So I just dove into my first ST-7, replaced tracking wheel, belts, DeOxit on pots, etc...
After much frustration, cussing, cajoling and downright threatening (it never seemed to listen at all, btw) it’s up and running and sounding great.
My issue is that the strobe speed is off.
When...
Hi Collective!
I found this stray singleton and can’t seem to find any info on it.
Just wanted to know if it’s of enough consequence to repair or not.
It’s a Yamaha 4563 tweeter. It looks to have a 1” beryllium diaphragm.
Any thoughts as to what it belongs to?
Thanks!
Well,
Made a bit of headway.
Cleaned all 523 pots and switches again as well as the speaker clips, and managed to retrieved the rear left channel from the upside down.
However, the right front is still missing in action :(
Interestingly, I’m am now getting bleed-through sound on all 3 good...
Ah, good to know.
This one doesn’t have the pre-out/ amp in scheme or I would have tried the test the preamp/amp tactic.
Or is there another way to test them independently?
Oh, and I did pull the lid off and clean the relay (it actually looked a lot nicer than some others I’ve been into)
One thread I saw mentioned that the level set (4 banger) pot was bad. I did manage to extract it enough to clean it, but it is a mother to get to...
I’ll check on the speaker...