Electronic novice question:
I soldered a silicon diode (+/-) onto a board. The two holes on the board were very close and I was a little heavy handed on the solder and I barely see any "green board" between the two joints. I want to assure I didn't short the two leads together.
To test for that I would just check for continuity between the two leads? If there is continuity then I have a problem? Is that correct?
I soldered a silicon diode (+/-) onto a board. The two holes on the board were very close and I was a little heavy handed on the solder and I barely see any "green board" between the two joints. I want to assure I didn't short the two leads together.
To test for that I would just check for continuity between the two leads? If there is continuity then I have a problem? Is that correct?