Technics linear help needed

I had a similar issue with an SL-QL1. On that machine, I hooked up a cable to a jumper on the back to adjust the servo gain and alignment. I found the centre readings for the arm were a bit off. I also found the adjustments couldn't be done within range until I replaced the capacitors in that part of the circuit.
 
Thanks for the replies guys. I'll have to recap the servo part of this unit and see what happens. I hope I can figure out where it is. I wonder if buying a cheapo capacitor tester would make repairing things like this a lot easier.
 
Back
Top Bottom