Only two problems at the moment. The circular power switch is stuck in the open position. No big deal, I can place an inline switch. The main problem is that it skips, and I've set it up properly. It was clearly a DJ table and I only paid $25 bucks for it. The arm had no play in it, but I think it's a worn pivot. I had this problem before, and I thought it may have been because the table wasn't level. My current rack is spot on level, but it made no difference. I can buy a new pivot assembly, but I understand it's a bear to install. Any suggestions?
How are things! Nice to finally meet you.Only two problems at the moment. The circular power switch is stuck in the open position. No big deal, I can place an inline switch. The main problem is that it skips, and I've set it up properly. It was clearly a DJ table and I only paid $25 bucks for it. The arm had no play in it, but I think it's a worn pivot. I had this problem before, and I thought it may have been because the table wasn't level. My current rack is spot on level, but it made no difference. I can buy a new pivot assembly, but I understand it's a bear to install. Any suggestions?