speaker

A bit of googling, but still no good information. What is this thing? There was one of these stuck on to the back of each of the very nice ProAc speakers I recently picked up. I immediately removed them, thinking it's a gimmicky or otherwise useless device. Anyone know what it is, what it does...

Purchased a pair of ProAc Tablette 50 mini monitors from a nice local couple. They'd wrapped the speakers in towels and had them stored in boxes for many years, and finally decided to sell them. They're pristine. But they stored them in possibly bad orientations in the box, on the side, and...

I have the Celestion SL6si, and I like them a lot. They are detailed in the treble but not necessarily that open sounding up there. Would the rather small ProAc Tablette 50, give me anything that I don't already have with the Celestions? Some people rave about them. I am listening in a smallish...

I'm probably in over my head again, that's why I'm turning to AK. I am endeavouring to repair a crossover that I'm sure is faulty, somehow. It's for a Rogers LS7. I'm sure it's faulty because I've tested the woofer and tweeter and they're producing sound when a signal is applied directly. All...

Hello, Is it right that you connect the sub on the remote speaker termials on a Maratnz 2270 and the stereo speakers on the main terminals? So when you are listening to music you should have both main and remote speakers switches turned on. Is this bad for the amplifier or is a 2270 made for...

Long-time lurker, but first-time post. In the mid-/late- 80's I got a pair of Jamo Cornet 70 floorstanding speakers. The label on the back says: Rated power: 90W Music power: 120W IEC (268-5): 40W Impedence: 6 Ohm I'm trying to find out other information about them -...

I need several small powered speakers for a sculpture project, but the nature of the project implies specific requirements. The speakers will be installed on a flat board hanging on a wall, and covered by a mask that has low clearance. no bluetooth needed - wired AUX input mandatory. Ideally...

Hello, I am posting a new topic because of what I found out so far. I'm new to the forum and am also new to repairing audio DIY style, so let me cut to the chase. I've acquired a pair of ATL Celebration speakers (quite unknown but sound terrific), and they seem to be suffering a problem. ATL...

My purveyor of vintage audio or anything, send me a couple of photos. The guy just hussles stuff, he doesnt research or anything. So the prices are usually great. got a amp and a pretty cool receiver from him. Hoping for a marantz or Mc, one day. Anyway, one is clearly a very cool jvc, looks...

Badge says 'High Definition Monitor'. I was given some somewhat de-constructed floor standing speakers and would like to get them working. So far I have just one power ed up and the woofer but not the tweeter works. Also I am wondering if they worth working on from the standpoint of how will...

Parked night before fine, start up next day its out. Its never gone in or out before so no hint of bad connection. Banged on dash nope slammed door a few times nope. still out today wiiggled wires in door jamb nope tweeter that side works. I never crank it and it doesn't get that loud...

Post deleted. Found an answer from schematic.

Hey all! New here! I’m working on rearranging my setup because I inherited 4 of these KL-888A speakers. I only have one hooked up right and it’s wired into an RCA adapter and plugged into my receiver which my tape deck is hooked up through. The speaker sounds fine (no rattling or anything...

Picked these up today at a thrift store, (well my dad did after scouting em out for me lol, I love that man so much) and upon doing some research on them when I got them home, I couldn't find any that have a woofer similar to mine. Anyone ever seen one like this or know the pros/cons of the...

Yeah, I can already hear the groans and see the eye rolls, but I want a small bluetooth speaker to take on trips. I bought a JBL GO 3, unboxed it today, and for me, there is too much bass. I’m thinking this may be a non issue for some folks, but to me, the music just doesn’t sound like its...

Hi all of you gurus. Yesterday I found a set of Marantz Imperial 7G speakers. All original parts... Contacted the seller, made a deal..for € 50,-- (indeed about 50 dollars also) ..I like to think that was dirt cheap. Picked them up today... I plan to test them Sunday during the Grand prix...

Hi all, I disassembled the head module on one of my KEF 105.2 speakers to try and replace an LED that glows at various wattage readings and helps you position the speakers. I decided I'll try to clean the connections (there's a small PCB in there) instead. Used Deoxit F5 and D5; sprayed visible...

I have a 2.0 PC speaker system which works fine but I'd like to increase the bass on it. I also have another 2.0 PC speaker system which doesn't work anymore when plugged into the mains, but it's still possible to use the secondary speaker if you connect it directly to a phone or a laptop...

I'm hoping to build wooden enclosures for these PC speakers I have. The drivers I'll be using will come from 2 different 2.0 PC speaker systems, and I'll be putting one driver from each into each "new" enclosure. I would also like to put passive radiators into the new enclosures. I've heard in...

Have just acquired a pair of Technics SB C-250 vintage speakers. Generally they’re positively reviewed and I’d like to get them performing at their optimum. Questions: -What is the key quality one should seek in capacitors being used in a loudspeaker crossover (low leakage? or something...

Ok so this is gonna be of an info/ photo dump. Please bear with me as any help would be greatly appreciated. The belt slipped off my LXI and I took everything apart to get it back on. I get the belt on and once I got everything reassembled everything seems to be working, but I'm having full...

So I have a set of 1 1/2’s and a set of 3’s. They are great speakers. Today I grabbed this set for $25 that look like Klipsch KG4’s. They have 2 - 8” woofers and a horn tweeter in them. The grill has a DLK logo and the back has a serial number sticker. Any ideas on what they are? See the pics...

My guess is that you just put it on contact with bare speaker wire but I'm not sure. Thanks.

Hello! I have an Pioneer AZ-470 amplifier, and i have issue with speaker A+B mode - it is not working. Speakers A and B works, when set separately, but when i toggle speakers A+B setting, it's not working. Any ideas why so? Do i need all 4 speakers to be 16 ohm's instead of 8? Thank you!

Given a nice pair of nonworking HH Scott S2 speakers. In great shape and well constructed. Taken apart and all speakers read appropriate resistance and appear to work. Cross over needed all four 50 ohm rheostat rebuild, careful wire wheeling and soaking in deoxit, a little soldering all work...