volume potentiometer

  1. Brian OD

    Help with Realistic STA-46 Volume Pot

    Good Morning all. New to the forum and have a question. My Mother In Law works at a local “Goodwill” type place. She just brought me an STA-46 that showed up today. I wasn’t expecting much; plugged it in and hooked it up to my speakers. My Goodness! I was blown away by this thing. When I would...
  2. J

    Marantz 7 Volume Pot?

    I had my Marantz Model 7 restored last year after many years in storage. Since then the volume pot has been getting more and more scratchy in the right channel until around 11 o’clock. The volume pot was not touched during restoration as it sounded fine at the time. I brought it back in to...
  3. dapbmw

    Sansui G-8000 volume potentiometer cracked problem

    Been restoring this g-8000 for 4 months now. It had the volume cutting out issue and Looked at the f-2800 board and it’s been worked on before as in someone removed the volume lot before, one of the top terminal tabs grey wire connected was loose and it’s broken off from the wafer. Since...
  4. Rodrigo mtz

    can a volume pot be restored?

    i own a Gradiente model 80, it has been with me since new in around 72-75, but lately its been having this problem with the volume pots were sometimes i wont get any sound at all, and sudenly without touching the knob it will go intoo full volume, in other times it will just refuse to do...
  5. firealley

    McIntosh column pot connector to balance pot broken connection

    hi folks, I Need help to repair my Mcintosh 1900. The connection that comes from the volume pot and connects to the balance pot is broken. It's broken at the resistor. (I think). I'll post the pics. I've thought about repairing it with epoxy or replacing the resistor. Can someone out there give...
  6. Ricktptman

    Another C-28 S.O.S.

    I thought I had this preamp settled down and it was behaving fairly "rehabilitated" until very recently. I'm fairly certain it's the volume pot. I have another one and installed it and it works "kinda sorta". Very odd things happening with the channel balances. I I think I see ground wires...
  7. Ricktptman

    Is anyone familiar with this replacement C28 potentiometer?

    I should've specified "Volume" in the header. But I figure most folks will know that's what I'm asking about. I saw this on Epay. # 152942282464 I have a few "smallish" issues with mine. They're not as crazy/egregious as some I've read about, but I'm interpreting it to mean that eventually...
  8. H

    Adjust MC2255 channel gain question

    Hi, I have been fine-tuning my very nice mc2255 amp. I have found that the gain on one channel is slightly higher (6%) than the other channel with both gain knobs set to max. I have cleaned both pots, but no change. I was thinking of adding a small resistor in series to the louder channel, but...
Back
Top Bottom