2270 volume control

Richs_Trains

AK Subscriber
Subscriber
Hello all, A few nights ago while moving my very heavy 2270, I bumped the volume control and bent the shaft. Is there any place I can find a replacement? I know better than to try to bend it back, but now it travels in an oval:yuck: Thanks Rich
 
That sucks, I am also looking for a 2270 replacement pot. Unfortunately there are no replacements that I have found. The pot is a 250k ohm dual taper with center taps for the loudness control. The center taps are what make it hard to find. I guess we will be dueling it out on eBay...[emoji51]
 
If it's only bent and not broken I have had success in straightening them.
It requires the use of a heat gun and a spare knob and great patience.
PM me for my phone # and I can walk you through it.

Bob
 
If it's only bent and not broken I have had success in straightening them.
It requires the use of a heat gun and a spare knob and great patience.
PM me for my phone # and I can walk you through it.

Bob, I just acquired a 2220B with a bent (not broken) volume knob. I would be interested in your procedure that you use for this.
 
Back
Top Bottom