Don't forget that 2SC2611 transistors need to be installed under the heatsink:
Is this your pic from another thread?Don't forget that 2SC2611 transistors need to be installed under the heatsink:
I like the neat install and these transistors allow for that. Yes I am aware of the orientation. Thanks for sharing that pic and info.Yes.
Where did you find those 2sc2611 trannys? I need to fix mines too!One step ahead of you. They arrived today.
View attachment 1040428
Don't forget that 2SC2611 transistors need to be installed under the heatsink:
On eBay but I just looked now and the seller I purchased from is sold out, what he had went quickly and he had 9 lots of 5.Where did you find those 2sc2611 trannys? I need to fix mines too!
There is one other seller on eBay with one lot of 10 at a good price, search for syracusesemiconductorsWhere did you find those 2sc2611 trannys? I need to fix mines too!
Time to pin her back together and give it a spit shine!
You wanna buy one? Comes with a wood case to! lolCongrats. Don't have one but was watching your thread with interest. I like to hear success stories!
and thanks for your help/input!Glad you got it fired up! well done.
So I got c2611 transistors to replace the 34-1006 on the scope board. I can't figure out the pinout install. So do they replace with same pinout or do I have to install them upside down under the heat sink? Which is it?Actually the Hitachi 2611's have the same lead configuration as the originals, I just got done checking them. What did you say you used?