Bulb size for SA-7500, SA-8500, etc.?

[lowredmoon]

I know the SA-7500 takes an 8v 30mA, (or close to it), but I do not know the form factor.

Is it a T-1?

Thanks,

Adam

 

[lowredmoon]

I found the right bulb. It's rated at 50mA, but I think it'll work just fine. I'll change the resistor if necessary. The size is T-1 1/4.
http://www.mouser.com/ProductDetail/JKL-Components/DW50/?qs=sGAEpiMZZMucm/%2bFOY0TQptSuWzgFzWYqdEcgKh9M9c=

 

[QSilver]

That's good to know, I know that a lot of people here use https://sites.google.com/site/dgwojocom/ for getting hold of replacement bulbs. Incidentally, I think the bulbs is a 8V 50mA 4mm

 

[lowredmoon]

Hey, that's even better for less experienced solder iron operators if they come already terminated. It's good to support the small seller when possible.

 

[KingBubba]

The on bulb for my SA-9500II was a five mm. Dgwojo sells them with and without tails. Save yourself the possibility of a soldering error and get the ones with the tail.

 

[QSilver]

My thoughts exactly