Chain saw won't stay running under load

Discussion in 'General Off Topic Forums' started by Andyman, Jun 2, 2013.

  1. jami w.

    jami w. just being me thats all

    Messages:
    2,938
    Location:
    New hampshire
    Here's my take, used to own a jonsred , anyways if it bogs while cutting, remove. All gas, replace all fuel lines filter take Carb of rebuild n clean it!!!!!! Very important once you do this should run fine!
     
  2. Klownschool

    Klownschool Mouth open = can't hear Subscriber

    Messages:
    7,209
    Location:
    Monroe, WA
    I had two saws that had the same issue. The carburetor came loose. Make sure it's appropriately fastened.

    Good luck!
     
  3. daniberry

    daniberry New Member

    Messages:
    1
    One should change oil filter and engine oil for its proper working. Make sure it is proper tuned.
     

Share This Page