Check out my TU-999! - Rubber Feet For It?

DaveThreshol

More Q's than A's.....
From an estate sale. I wish I could say that I got it for $15 but it was $95. OUCH! Works just like a new Sansui!
Anyway, it does not have the rubber feet. I found a store on Amazon that has rubber feet for your every dream. SO, my question is, does anybody know the actual SIZE of the original rubber feet so I can duplicate them as closely as possible? 1" tall would give just barely enough room under the faceplate.
below the pic is, "Linear Motion Labs," the rubber feet experts on Amazon. Sansui TU-999 A.M. - F.M. TunerIMG_0010 - Copy E.JPG
https://www.amazon.com/sp?_encoding...rderID=&seller=AKUUVNVXBG8SV&tab=&vasStoreID=
 
I would order several sizes and use the one that allows a good amount of clearance but not too much. I guarantee you will use the extras at some point in the future!
 
Happen to have a 999 here the original feet are 30mm or 1.1 inch tall and 24mm or .95 in wide.
 
Back
Top Bottom