Connoisseur BD2-A rubber motor mount advice needed

I don't know the specific mounts but sometimes rubber o rings can be added to at least improve the mounting isolation.
 
Has anyone successfully made mounts for them?

Bay:

https://www.gumtree.com/p/other-ste...ural-rubber-web-suspension-kit-for/1305668668

https://www.ebay.co.uk/itm/BELT-AND...-BD2-TURNTABLE-/323395485656?oid=323277407466

s5l25l.jpg
 
thank you very much,
does anyone have a pic of the motor unit installed? are there any screws or something that go into the two black long tubes on the side?
the motor is held in place with two self tapping screws into the motor mounting plate.
what is the purpose of the platic bacnd - i see the one pin for an elastic that is exists, what about the two long tubes?
tia, pics later if possible.
 
this is what mine looks like. what do the black tubes on the side do? i get that the pin is for some sort of rubber band restrainer.
the model is a BD2 A.
Img_5722e.jpg

I have some lovely new rubber that is the same thickness and feels the same durometer and will make a triangular mount to try it.
does the pulley pull off easilyIMG_5720.JPG ?
 
Back
Top Bottom