Crimped PCB Terminals - part number.

Thanks John! These pins (P/N 571-3-42642-3) are also available at Mouser in the USA, saving all that "pond postage". They fit nicely in a 5/64" (2mm) hole.

These things can be almost priceless when working on an old Sansui PCB with brittle traces. I looked hi & low for them everytime I had to replace OP TRs on the F-3058 bd in the G-6700. Finally had to settle for some modified connector pins.

Is there a thread somewhere (DIY?) to document these terrific finds?
 
Back
Top Bottom