First ignition with restored sx-838

[frisouille]

Dear Friends here we are,
My sx-838 is full restored. I crossed my finger, put my DBT with 150w hallogen bulb (116w) on and i set the bias/offset.
Here my measuring voltages:

awm-025 protection board
pin 1 amp out, -0.01v
pin 2 -12.62v dc
pin 3 amp out, -0.01v
pin 4 ground
pin 5 over current sense
pin 6 over current sense
pin 7 over current sense
pin 8 over current sense
pin 9 relay coil
pin 10, 11 +31.6v/+31.6v
pin 12 +6.2v AC

awr-055 power supply
pin 7 -34.3v dc
pin 9 -12.6v dc
pin 13 +31.5v dc
pin 14 +12v dc
pin 21 +9.8v
What are you thinking about this values, should i go without hte DBT?
Thanks for helping me....

 

[tsd71]

is the bulb going dim, and is the relay clicking

 

[frisouille]

Yes the buld is very dim, the relay click and the amp go on.

 

[kdris10]

those are good numbers for being on a DBT, turn VR3 & VR4 fully counterclockwise turn VR1 & VR2 half way and fire it up, should be no issues. Then make adjustments as per the service manual.

 

[frisouille]

OK, will do that.
Thanks.

 

[buzshaws]

OK, will do that.
Thanks.

How are we doing frisouille, everything work out well? The suspense is killing me!