Mitsubishi DA-A10

tillmbil

Active Member
Hello all,
I was hoping someone could help me out with a cap replacement issue. It appears I cannot determine the cap replacement for C317. I was interrupted while removing it by a neighbor and failed to list the value and direction of reinstall. Upon looking at a schematic it look like a 1uf 100v. But when looking at all the caps I removed the only one that seems un accounted for is a 220uf 63v. I was hoping someone could decipher this one for me.

Questions. If I installed the 220uf 63v in place of the supposed 1uf 100v would this blow something else?
I will attach pictures. I am hoping someone has knowledge of this amp or could figure out from a schematic that I can take a pic of if needed.

Any help will be greatly appreciated, totally bummed.
 

Attachments

  • DA10.jpg
    DA10.jpg
    74.9 KB · Views: 22
  • MitsDA10.jpg
    MitsDA10.jpg
    83.7 KB · Views: 20
I've found a couple of versions of the DA-A10 schematic online and can't find a C317 in either.

Terry
 
Here is what I replaced:
C311 22uf 63v - 1 PW
C313 22uf 63v - 1 PW
C312 1uf 50v - 1 FG
C105, C205 220uf 25v PW
C202, 102 33uf 25v np ES
C207, 107 22uf 25v np ES
C59, C19 470uf 80v PM
C56, C16 2200uf 63v KW
C314, C315 220uf 63v FC panasonic
C201, 101 1uf 50v FG
No idea what to do about the C317 spot. Leave it out all together? I went through my caps and list again, and everything checks out with one cap left and it is the 220uf 63v
 
According to the service manual the C317 1uf/100v is only used in the DA-A15. The DA-A10 does not show it.
Check that you have the correct diagram. The DA-A10 does not have C317, D307 (Jumper in the A10) and R307 is 390 ohms/3W instead of 470 ohms / 3w
 
Back
Top Bottom