Cajunchuck
Active Member
Hi folks was wondering what the heck is going on with my 850. When I power up it will only play one channel in stereo mode (the right). Works normally in mono. After warming up a bit it MAY fix itself when I throw the switch into stereo. No noise/crackling or anything on any controls (I deoxited it when I got it). Any ideas where to begin looking? Hopefully something simple. Thanks!
Oh and this. It only does that on certain inputs (the radio and aux). Other inputs work fine (I'm using one of the tape inputs for TV/movie sound).
Edit to add:
I fess up that I'm using the pre-out jacks to run my Soundcraftsmen amp to a pair of CV D9's. I have not tried running it with the built in amp, mostly because it's nestled in a hard to reach cabinet and I have been too lazy to get back there and switch it over. Not sure if this matters though. Hope not LOL.
Oh and this. It only does that on certain inputs (the radio and aux). Other inputs work fine (I'm using one of the tape inputs for TV/movie sound).
Edit to add:
I fess up that I'm using the pre-out jacks to run my Soundcraftsmen amp to a pair of CV D9's. I have not tried running it with the built in amp, mostly because it's nestled in a hard to reach cabinet and I have been too lazy to get back there and switch it over. Not sure if this matters though. Hope not LOL.
Last edited:
