Yamaha CR-400 Quick Recap

Measure your voltage from TP1 to E and TP-3 to E. And post results.
 
Measure your voltage from TP1 to E and TP-3 to E. And post results.
I apologize for not understanding, but by E do you mean earth, the emitter of the output transistor, or some test point I'm not seeing? If to ground, there's -2 volts on each. Bias is .3 volts at minimum setting.
Also I mis-installed TR612/611 but no change other than the power led is very dim now.
 
Took out the outputs and it passed the DBT, reinstalled all output transistors with new insulators and the pads cleaned but to no avail. DC balance is adjustable but hangs around 2 volts. Bias is adjustable but around the volt range. Triple checked all transistors in power amp were installed correctly.
 
Back
Top Bottom