Yamaha NS1000M Discussion

Where did you get those from?
A friend of mine made them for me using a laser cutter. He's done a few sets, mine are "one offs" only set that the black pierced YAMAHA logo part is actually in dark grey tinted acrylic.
I really like the very dark grey smoked acrylic as it lets just a tiny amount of light reflect through it from the shiny silver layer below.

Here's some of his others:

 
Last edited:
Turned subs back on today, made small adjustment to attenuators. Here's a doctored pic, I added -1dB and -2dB marks to make it easier to tell where they are.
 
850B70D2-EE60-4F7C-A459-87D8C3A637E6_zpswpjthjaw.jpg


I likey...
 
Mark,
I like your doctored attenuaters, wish that's how they actually are.
So which way did you reset them, forward or back?
I wish they were labeled this way too.
I added a dot on the dial as well so you can tell I cut both high and mid by around 1¾dB, anymore seemed too much with the subs on too. had them at -2dB with the subs off.
 
Last edited:
Badge comparison pic, left is clear in center, right is clear on top.
My preference, clear on top should keep the laser cut section cleaner over time.

 
Last edited:
That's the correct way to dial in,/fine tune a speaker with attenuaters. Tiny movements can make or brake a speaker sounding good or not.
Too bad so many people just didn't understand this.
Nice badges, by the way.
 
Back
Top Bottom