Picture of IRS Beta: Inside the Crossover box

[wsill]

Hello,
Can someone post a few pictures of inside their IRS Beta crossover box? Or know of where some are posted?
I need a reference point of an un-modded crossover.

Also:
I see on the schematic on the Infinity Classics.de site:
http://www.infinity-classics.de/mod...-Delta-Sigma-Epsilon-1988-95-98/index-IRS.htm
Fuses, where are these fuses physically located?
Thanks,
Bill

 

[Ervikingo]

Did you figure this out?

The mids on one of my wings are off???

 

[Ervikingo]

Caps are held in place with hot glue. Some came loose and welds failed. All corrected. Now issues with low frequency. As I posted on the other thread:

Some caps were loose on the crossovers. Fixed that and now...

I have gone through all the wiring. All correct, all in phase, outlets are in phase also.

With power amps off, Servo Control goes and stays green! As soon as I power on either or both (left/right low frequency amps) get a lot of hum and the woofers vibrate like mad and Servo goes on fail mode (green led off). System cycles at approx. 15 seconds and the problem repeats.

Red control cable is on right side as should be.

Ideas????

 

[Rollie123456]

Hello,
Can someone post a few pictures of inside their IRS Beta crossover box? Or know of where some are posted?
I need a reference point of an un-modded crossover.

Also:
I see on the schematic on the Infinity Classics.de site:
http://www.infinity-classics.de/mod...-Delta-Sigma-Epsilon-1988-95-98/index-IRS.htm
Fuses, where are these fuses physically located?
Thanks,
Bill[/QU


Hi Bill,

attached you find an unmodified passiv x-ovver. You‘ll find the circuit breaker between the capacitors and the inductor (left for Front-EMIT and right for EMIM).

 

[Rollie123456]

Hi Bill,

attached you find an unmodified passiv x-ovver. You‘ll find the circuit breaker between the capacitors and the inductor (left for Front-EMIT and right for EMIM).

 

[wsill]

Thanks a bunch for the pictures!!