• Check out the Annual AK Secret Santa exchange Program, signup before November 23rd in the AK Charities & Christmas forum!

SX-450 output distortion

SX_450

New Member
Hi,

I've got a Pioneer SX-450 that works great except that there is an distortion on the output. When you turn on the receiver the distortion is much louder, then it stabilizes in about a second. It's both on speaker A and B. If you measure the output the right speaker starts with about 8V and stabilizes around 0.03V and the left speaker starts at 11V-2V and stabilizes at 0.003V.
Could it be that a capacitor is broken or is it something else? Anyone who knows how to search for the broken part or knows what to do?

Thanks!
 
Register to hide this ad
Okay, any idéa how to replace it? There's always a little distortion, this is also the bad power switch?
Thanks!
 
Short the switch out to verify the problem. Switch can be removed and cleaned. Sometimes that is sucessfull. Option 2 is leave it shorted and plug unit into a power strip to turn on and off
 
The power switch is a very common problem, that is correctable, it just takes some careful disassembly /reassembly. Here is a quote from a recent post on the subject. Follow the links for pictures.

Charlie, the 450,550 and 650 share the same type of switch and problems.

it is a very common problem.

there are several threads detailing the disassembly of the rotary power / speaker switch, and the burnishing of the burned contacts. It takes an hour or two to free the thing up, and you will have one of two styles of switch (plastic or metal), and the plastic one could have a ultrasonically welded case. The metal one will need some VERY small screws to put back together after the rivets are drilled out.

here is a partial thread on the only METAL switch we have encountered

this is a sx-650 thread with pictures

Rabbi Rich also did a sx-450, but it was just mentioned in passing.

Here is a link to that thread, which ends successfully.
 
Hi!

Thanks for the help! Did some research in this great forum and found some threads about the power switch, did the disassebly and cleaned it but unfortunately no luck. Maybe I'll have to replace it. Gonna try to shortcut it if that's what grateful meant? It's also is printed 2A/32A on it, is there resistors in it then?

Thanks again!
 
2a/32a is the current rating of the contacts.

IIAC 2 amp continuous, 32 amp surge max.

No resistors inside. It did look like the pictures?

Do the lights still flicker when you turn it on?
 
Okay. Didn't really looked like the pictures but almost. Instead of one place it connected it had two, and there is 4 cabels connected to the power switch.
Lights are completely dead so theres no flicker at all. :(
Guess I'll have to shortcut it next time I take it apart, I can take some photos then.
 
Back
Top Bottom