salamander said:
...But cartridge BROADCAST ONE I do not know the brand of the stylus . I read that the magnetic system of the BC ONE is the same as the cartridge 2000Z . This is obviously so - I measured it inductance and resistance . They are similar to the data 2000Z . But the needle cartridge BC ONE - conical , it was cartridge for radio stations . Can You tell me what type of stylus better suited for the BC ONE ?
First, welcome to the AK turntables forum, and thanks for measuring the Broadcast One's inductance. I think we're all surprised to find it that high! I think we can find a stylus better suited to your purposes that will work in the Broadcast One body.
Since the 2000Z, 2000T and some clones have unique internal construction, including laminated pole pieces, I'm afraid there is no perfect solution, since I have no evidence that the Broadcast one has the laminated magnetic circuit.
Still, aside from the Broadcast One's original stylus, the only Empire styli that were designed to give flat frequency response inside an ~800mH body (@1kHz) are the 2000Z, 2000T and S915E styli. But as Doug G. told you, the brass "shank" or tube of the 2000Z stylus is smaller than the hole in the Broadcast One's body.
So, if I were the one with this problem, I would get a 2000Z/T or S915E stylus, insert the shank loosely, then glue the plastic grip to the outside of the Broadcast One body with a little silicone glue. It may take some trial-and-error adjustments to get the channel balance correct. Overall output may be lower as well.
I couldn't guarantee that the frequency response curve would be flat from 1kHz out to 20kHz. Instead, I would expect the graph to tilt downward toward 20kHz. This could be corrected, at least partially, with a tone control or with 100kohm loading at the input to the RIAA stage.
Alternatively, you could use the best styli from the 2000E series (S2000E/III/II/I), which were designed for bodies having ~600mH inductance. Again, you'd have to deal with a frequency response curve that was not flat, but wouldn't be too far off. I'd expect a broadcast cartridge to have a "shaped" response curve anyway.
Do either of these kluges appear appropriate to your problem?
GrampaDave: Sorry, I somehow thought you had the whole package. I think the EXL 10 is only around 350mH, though the spec sheet doesn't... specify. Do you have an LCR meter handy?