QS-500 Hook-up for basic testing...

[Sansui70s]

I'd like to do a basic test run on this newly acquired rear-channel amp (without hooking up to my 5500)...Is there a way to source feed a signal (Bluetooth device perhaps?) to the amp, to test its output to the speakers? I did download the fairly detailed factory Manual, with all the great diagrams to connect to a Receiver, but believe that it could be set up a a stand-alone, at least for testing...Thanks in-advance for any guidance!...(I'm kinda new to this)

 

[KeithD]

Just put a two channel source into the QS-500 in the RCA jacks and connect speakers. You'll get the rear channel output out of the speakers.

 

[Sansui70s]

Just put a two channel source into the QS-500 in the RCA jacks and connect speakers. You'll get the rear channel output out of the speakers.

Thank you!...ok, on the 2 Chan section, "rec" or "mon" side? (or does it matter?)

 

[KeithD]

You can use the "Front Amp" "From Rec Out" to input a signal.

 

[Sansui70s]

You can use the "Front Amp" "From Rec Out" to input a signal.

Thank you!