• Check out the Annual AK Secret Santa exchange Program, signup before November 23rd in the AK Charities & Christmas forum!

2252B: damage/repair help please

Adam88

New Member
Hi all,

I went to replace the tuner needle bulb on my receiver, and while soldering the new wires to the posts, I accidentally bumped a couple of components alongside. I admit, embarrassingly, that it was powered at the time and playing music, and no lectures needed. Eazy peazy.., and dumb.., I realize. All lights went out, and the speakers made a dwilp sound and went silent. I unloaded/moved the stereo cabinet, finally accessed the plug, took the receiver down to my work table, and noticed the 2A fuse was toast, alongside the wire post, and replaced it, which brought back all of the lights, but still no sound on any input. You can see where I also slightly touched the square black component, forward of the fuse (sorry, don't know what it's called, I don't have extensive electrical/repair experience). Can anyone advise on what to troubleshoot next, before making the drive to the repair shop in the city? Unplugged of course, on work table, under work light.

Many thanks in advance

1000009232.jpg
1000009234.jpg
 
Register to hide this ad
Give me your hand...so I can slap it!
The square black component forward of the fuse appears to be a transistor, based upon the ID on the board (Q748). The black surface appears to be plastic so no harm should have come to it. Check the surface to verify if it's plastic and then read off the writing on the side of it so we can identify the part.
I accidentally bumped a couple of components alongside.
Can you identify the components you "bumped".

Honestly, your next visit should be to the repair shop as these types of "oops" usually result in a detailed troubleshooting beyond most folks capabilities. You also need the equipment for troubleshooting ...what do you have available?
 
Appreciate the quick reply, @eiraved . And I wish I could say it was the dumbest thing I'd ever done.

Here is the side of the transistor (thanks). And looking at the board again, I suppose it is equally possible I bumped this J711 post, by the end of the fuse, adjacent to the post for the bulb wire. I have a multimeter but that's about it for diagnostics.

1000009245.jpg
1000009244.jpg
 
I agree on the post, although it could be any of 3 posts near the fuse (green and yellow post wires), based upon the mark shown on the transistor.
 
Your next step is to get the 2252B service manual. You can find it by searching the AK database. Locate the posts you touched and see where they lead to. There you can figure which path is causing the current symptoms the receiver is exhibiting.
 
Hey, I did it at a job back in the '80's, but got away with it. The part I replaced was bad and it was working after I soldered in the new one! Lucky!!

That part is a dual rectifier and that's not the issue, you hit another live post as others have mentioned, and perhaps the soldering iron tip is a grounded one. Hopefully you didn't blow open a transformer winding.
 
Q747 and Q748 are not transistors. They are dual diodes (rectifiers for a power supply). Look at the symbols on the side of the devices. One is common cathode, and the other is likely common anode.
 
Thanks guys. I gotta call it quits for tonight, but will hopefully find manual and any schematics tomorrow/wknd and see what I can figure out. Really appreciate the help so far. And yes, I was shaking head, typing the admission.. I am a walking collection of dumb decisions, hold my beers, and minor miracles.
 
Back
Top Bottom