quiet
Addicted Member
I've had to many toys in the play room for a few months now. It has come time to either finish the project or sell the parts. So I rounded up the remaining items needed such as 500 feet of 16 gauge wire, 120 RCA connecters, 100 feet of antenna lead, FM roof top antenna, antenna rotator, antenna splitter, adjustable FM amplifier..........about $125 mostly on hand or friends or used, not bad.
Friday afternoon I started clearing the amps out of the way for the redo, simple enough. That's when I realized the speaker stacks had all the simple positioning mistakes that were to be had. To close to the wall, not enough separation, facing the wrong way, wrong stack order, box rotation...........
Ok, time to break the crane out. A few hours later they were all stacked up again, simple enough. So I plopped a receiver on a desk for a test, connected the speakers, and pushed the go button. Big difference, super responsive and the bass is lower, faster, cleaner. It's all good, the speaker part is done, simple enough. Well, no it's not.
It's not long before I realize the speakers are shouting at me, very responsive they now are. I figured it was the mid's and hi's , can't be anything else. So I turned them down at the amp, simple enough. No, it turns out this would need to be done at the speakers. So I run around and adjust all the speakers collectively in one fell swop, simple enough. No, turns out I had to adjust each pair of speakers, not just in pairs but separately from left to right also. It was mostly the mid's that were to up front. It's done ,it sounds marvelous.
Now all that's left is to get the 20 receivers plus a R2R and turntable into the new hole.
I'm sure it will be simple enough.
Even thought I simply don't know where to start
Friday afternoon I started clearing the amps out of the way for the redo, simple enough. That's when I realized the speaker stacks had all the simple positioning mistakes that were to be had. To close to the wall, not enough separation, facing the wrong way, wrong stack order, box rotation...........
Ok, time to break the crane out. A few hours later they were all stacked up again, simple enough. So I plopped a receiver on a desk for a test, connected the speakers, and pushed the go button. Big difference, super responsive and the bass is lower, faster, cleaner. It's all good, the speaker part is done, simple enough. Well, no it's not.
It's not long before I realize the speakers are shouting at me, very responsive they now are. I figured it was the mid's and hi's , can't be anything else. So I turned them down at the amp, simple enough. No, it turns out this would need to be done at the speakers. So I run around and adjust all the speakers collectively in one fell swop, simple enough. No, turns out I had to adjust each pair of speakers, not just in pairs but separately from left to right also. It was mostly the mid's that were to up front. It's done ,it sounds marvelous.
Now all that's left is to get the 20 receivers plus a R2R and turntable into the new hole.
I'm sure it will be simple enough.
Even thought I simply don't know where to start
Attachments
Last edited:

