• Check out the Annual AK Secret Santa exchange Program, signup before November 23rd in the AK Charities & Christmas forum!

BA A70 - Woofer Surround Replacement Project

two sevens

Active Member
Hello All,
So I am new here and new to the world of vintage audio and for that matter “quality” audio of any sort... but I am trying to change that. ..

Anyway, I have been looking for some speakers to use with my Sansui 881 receiver and realized my dad has an old pair of A70's in the closet, but the foam surrounds are completely gone. I would like to rescue these and do the re-foam myself. I have done a little research and it looks like replacing surrounds isnt all that complicated, but I still have some questions:

-Where's a good place to get the replacement surrounds for the A70?
-Will any surround of the same size/configuration do?
-How much do these cost?
-Can someone walk me through the replacement process or point to the best internet resource for this?
-What’s the deal with cutting the dust cap and shimming the voice coil? (sorry I know very little about speakers) Do I have to do this?

Thanks for your help. Any and all advice is much appreciated.
 
Register to hide this ad
Starting point for you is to use the "search" function at the upper right corner. Search the forum using keywords like 'refoaming' or 're-foaming' (once you start you will see other key words to use). Then start reading....there is a lot of info in here but start by doing your homework. Once you have gone through that process, then we will all gladly assist with specifics ....

And, YES YOU CAN to adopt a recent successful slogan! Re-foaming ain't rocket science....
 
Make sure that those speakers use generic surrounds. I had a pair of A150s and they used a special surround where the inner edge had a smooth transition from the roll.
 
Easy speaker to refoam.

I use the "D" battery method on the Boston "A" series with great results.

Be sure to get the proper foam- AK member GordonW deals with repairing BAs, and former AKer re-edger has supplied me with the correct density and angled foam.
 
I use a D battery also, I connected it with the right polarity when I glued the foam to the speaker cone to push it out and again when I was applying the glue to the speaker rim.

Once the glue on the speaker cone had dried I applied the glue to the speaker rim, then I reversed the polarity and that pulled the foam onto the rim keeping the voice coil centered.

Also when you glue the foam to the speaker cone I found on my first attempt that I have to look straight down to make sure the foam is centered as well, and there is an even gap between the edge of the foam and the speaker rim.

I let it dry for a while before removing the battery.

That's how I got it perfectly centered.

Hope this helps.
 
Back
Top Bottom