Calling JVC Direct-Drive Owners...

[cleverdick]

Please measure your spindles!

OK, I have a turntable that uses the motor assembly from a JVC QL-A75. The platter is not JVC and is not a good fit over the brass taper. Therefore, I am looking for a parting-out platter that will fit my spindle, which is:

13.5mm (upper diameter)
15.5mm (lower diameter)
18mm (height above step)

The QL-Y55F appears to have the same motor unit, but what else does? I've seen a few platters on eBay, but folks are too busy to respond to my questions at this time of year.

I would be pleased to know of any compatible JVC models with a platter that will fit.


Thanks guys

Rich

 

[Colin86325]

The JVC part number for the platter is provided in the service manual. You can try googling that number and seeing if it cross references with any other models. Or look at photos of models that are similar and then look at the service manuals for those models. https://www.google.com/url?sa=t&sou...Vaw0y87f1FFg9qe4xV1FZrH7M&cshid=1543379693047

 

[Balifly]

Please measure your spindles!

OK, I have a turntable that uses the motor assembly from a JVC QL-A75.

The platter is not JVC and is not a good fit over the brass taper. Therefore, I am looking for a parting-out platter that will fit my spindle, which is:


Thanks guys

Rich

What is the model number of the turn table in question ?