Connecting Dynamic Processor & Equalizer to SX-D7000

[kapohoguy]

I recently acquired an SG-9800 equalizer and RG-2 dynamic processor. I'd like to hook them both up to my SX-D7000 which has an "adapter" connection in aback for such things. My question is: How do I connect the the equalizer and processor to each other and which should be connected to the receiver? I haven't been able to find a wiring diagram for this set up.

 

[LesE]

The following is information I posted previously for an SX-1250/SG-9800/RG-1 combo:






On the SX1250, turn the Adaptor switch to ON.

If you want the signal to go through the RG1 before the Equalizer (Fig.4), set the SG9800 switches as follows:

TAPE MONITOR switch: ON
EQUALIZER switch: ON


If you want the signal to go through the Equalizer before the RG1 (Fig.5), set the SG9800 switches as follows:

TAPE MONITOR switch: ON
EQUALIZER switch: ON/RECORDING


If you want to bypass the Equalizer, set the SG9800 switches as follows:

TAPE MONITOR switch: ON
EQUALIZER switch: OFF


If you want to bypass the RG1, set the SG9800 switches as follows:

TAPE MONITOR switch: OFF
EQUALIZER switch: ON/RECORDING or ON

 

[kapohoguy]

Thanks LesE. Since posting this question I also found another thread with diagrams. http://www.audiokarma.org/forums/index.php?threads/connect-eq-expander-reverb-to-preamp.281053/
Not sure how I missed these in my previous search.