I am looking for any help, or a manual, or specs, or diagram on how to hook up my receiver to the DBX model SFC-1 SOUNDFIELD IMAGING CONTROLLER to the DBX model SFX-1 SOUNDFIELD IMAGING SPEAKERS. I got them from a local guy, but no booklets were with them. Thanks for any help, Kurt
DBX help
- Thread starter britbikes
- Start date
Register to hide this ad
dan-c
Perpetual Lurker
IIRC:
Tape out to tape in on the SF1.
Speakers normal to the receiver or amp. Run a small gauge (18 or so) from the speaker output on the amp/receiver to the monitor on the sf1 (yes, you'll have 2 sets of wires coming out of the speaker outputs). The speaker input on the SF1 is to monitor power going to the speakers. It will actually depower the output to the speakers if it detects clipping.
Hope that helps.
Tape out to tape in on the SF1.
Speakers normal to the receiver or amp. Run a small gauge (18 or so) from the speaker output on the amp/receiver to the monitor on the sf1 (yes, you'll have 2 sets of wires coming out of the speaker outputs). The speaker input on the SF1 is to monitor power going to the speakers. It will actually depower the output to the speakers if it detects clipping.
Hope that helps.