Does anyone have a nice clean The Fisher "bird" image file?

[grindfix]

Thinking about engraving or maybe silk screening one on the brass faceplate of the little amp I'm building from Fisher console chassis.
I'm sure that's been done before.
Thanks!

 

[Dave451]

I used this one before to make a brass plaque label for my SA-100 clone. It's not high res, but it's clean. Ok res for a small label.
Dave

 

[grindfix]

Thanks, Dave!
I think it will work for me.

 

[Dswankey]

Here's a couple more if they help

 

[gadget73]

there are some faceplate scans in this thread, not sure if any have a good enough image or not

Faceplate reprinting?

Has anyone found a person or company that can reprint old Fisher faceplates? I was hoping I could save the lettering on this X-202 but there is a lot of corrosion that already has ruined some lettering and much more that will get damaged polishing. I have had good luck on my other units, but...

audiokarma.org

**edit** ok apparently only one, the TA-600 face I scanned, and it doesn't have the bird on the face, its on the dial glass on those.

 

[ncwalz]

Here's a pdf containing a vector image of the logo.

 

[grindfix]

It went on to the faceplate of this little amp I built using Filharmonic transformers and most of the circuit

 

[gadget73]

I'm assuming the cans are over the Philharmonic iron? Mine are just open frame types. Sounds good but they aren't lookers.

Also el95 or 6cm6? My philharmonic runs ell80 but buying those are dumb money these days. Ell80 is two el95, but its not grossly off a 6v6, which isn't any different than a 6cm6 other than the bottle

 

[grindfix]

Yes, covers over the open bobbin transformers. EL95