• Check out the Annual AK Secret Santa exchange Program, signup before November 23rd in the AK Charities & Christmas forum!

dynaco sca 80q

kerrytat2

Super Member
Hi all,my basement workhorse,a DYNACO SCA 80Q may be on borrowed time,sounds great,but has never been re capped or serviced as far as I know(very clean inside though...I do clean the controls and what not but...).Bottom line,I always say I going to learn to recap a few of my toys but my work schedule would turn this into a year long project,any recomendations in the area of DYNACO servicing would be a great help,thanks!
 
Register to hide this ad
Hi all,my basement workhorse,a DYNACO SCA 80Q may be on borrowed time,sounds great,but has never been re capped or serviced as far as I know(very clean inside though...I do clean the controls and what not but...).Bottom line,I always say I going to learn to recap a few of my toys but my work schedule would turn this into a year long project,any recomendations in the area of DYNACO servicing would be a great help,thanks!

I am in the process of rebuilding a PAT-4 and I'll offer my ideas for what they may be worth.

First I think your biggest problem will be managing the solid core connecting wires. They can prove brittle and break. in the PAT-4 i've had couple break off when I touched them. Depending on whether you are working on a factory built or kit built may make a difference in this regard.

I am replacing these solid core wires as I work my way around.

I decided to do the rebuild in sections. I first did the power supply and line cord. The line cord was probably OK but it was very stiff after 40 years. I kept the power transformer and replaced the Electrolytics and their associated components along with new wires.

A couple of days later I disconnected the Tone Controls, I'll use and equalizer instead if necessary. Or I can always reconnect the controls.

Moved on to replacing the Volume control and wires with an 24step Attenuator.

In the process i discovered a cracked wafer on the selector switch.
Next project will be to replace the selector switch, Rear panel jacks w/ gold jacks on a new I/O board and to recap the boards. i will also order 1% film resistors for the boards.

Doing it in sections has allowed me to listen to the unit as work has progressed. The sonic improvement has been very noticeable and enjoyable!:D
 
I have four SCA-80Qs cluttering my house, two of which were acquired broken and brought back to life, so I can offer a few suggestions on this amp.

If memory serves, there are two non-polarized electrolytics on each of the power amp driver boards. One of them is in the feedback path. If this cap opens, the associated channel will go into ultrasonic oscillation. Change all four of them on general principles.

The diodes on the PC-19 power supply board have a 200 V peak inverse voltage rating. A spike on the power line can cause one or more of them to fail short, which will blow the AC fuse and silence the amp. Replace all four with new diodes of the same or greater current rating (3 A if memory serves) and a voltage rating of 400 PIV or greater. Reflow the solder joints on PC-19 while you're at it, since the heat from the four large bleeder resistors tends to age those joints to the point where they crack. Also check the solder joint at the lug that shares a screw with PC-19. This is the main ground point for the amp. Bad solder joints there are common, especially on kit-built units.

The output coupling caps are not heavily stressed and may still be okay. The two power supply caps are probably ready for replacement, though. There are also electrolytic signal caps on the preamp boards that should be considered candidates for replacement.
 
Back
Top Bottom