• Check out the Annual AK Secret Santa exchange Program, signup before November 23rd in the AK Charities & Christmas forum!

dynaco st70 bias question

boris777

Member
On my dynaco st70 (stock with updated bias and power supply and new matched tubes). I have it set for approx 1.5vdc. Upon startup though one channel is different than where it was last set.... like 1.6 something for a few minutes.

After about 3-5 minutes it settles and they both become approx the same (1.5) where I had set them last.

Is this fluctuation when the tubes are cold normal?
How much difference should I be concerned about when meausring with a dmm?
 
Last edited:
Register to hide this ad
My feeling is that this behaviour is unusual.
If you change place betwen left and right tube pairs , will this follow the tubes ?
 
From experience I can tell you that's normal. Check bias after ~5 min and then again after 20 to 30 min. There's nothing unusual going on with your amp.
 
All of my amps change from initial power-on until maybe 10-15 minutes of run time. Not a huge difference but enough to measure with no fuss.
 
Back
Top Bottom