• Check out the Annual AK Secret Santa exchange Program, signup before November 23rd in the AK Charities & Christmas forum!

Garrard 630s Turntable Setup Question

EMIparty

New Member
Hi,

I have a Garrard 630s turntable and when purchased it had a counterweight on the arm which consists of an aluminum weight with rubber boot that fits over the end of the arm. There is no adjustment that I can see other than just pushing the weight in and out to make adjustments.
With the weight completely back on the arm there is still too much down force on the stylus. I think it may be missing something.

I can provide a picture.

Anybody have any ideas ?

Great to be here at AK ...very nice site !
 
Register to hide this ad
I was not able to locate a downloadable manual for the 630s at vinylengine.com (closest I could get to the model number was 620s). They do have a Garrard forum, though, so if it is active you might be able to locate another owner who could share their experience with you, if there isn't one here that speaks up.

The manual does appear available for purchase, however.

Is this an idler drive table? Do you know your cartridge type/model number? I'm wondering if it's an older and/or less expensive table designed for ceramic cartridge use, and might not track light enough for a magnetic cartridge. It's hard to tell with a manual or having seen one.
 
I suspect that the rubber boot is actually supposed to fit in the counterweight, not over the stub, so that the rubber boot and the counterweight rotate on the stub and screw in and out. But with Garrard, who knows?
 
On my old 125SB, the counterweight threaded on the back of the S-shaped tonearm to adjust tracking force (and it was marked to show approximately how much), but there were no threads on the arm itself, so somehow the internal bore of the counterweight, or that part of the counterweight, accomplished that.
 
Back
Top Bottom