Hi all, I'm relatively new to this forum and I have a question that is probably obvious to most:
I just finished doing the BillD mods to my Carver C-1 Preamp (38 new caps, two new IC's and two new resistors). It was a de-soldering/soldering challenge, but everything works.
Until I finish my new amp project (a SE tube design) I was hoping I could connect the C-1 to the 330B and just use its amp section.
The HK 330B has Main Amp Ins and Pre Amp Outs. Does this mean I can connect the C-1 preamp to Main Amp Ins and only access the amp section of the 330B?
I want to use the 330B amp driven by my C-1 preamp.
Thanks in advance!
David
I just finished doing the BillD mods to my Carver C-1 Preamp (38 new caps, two new IC's and two new resistors). It was a de-soldering/soldering challenge, but everything works.
Until I finish my new amp project (a SE tube design) I was hoping I could connect the C-1 to the 330B and just use its amp section.
The HK 330B has Main Amp Ins and Pre Amp Outs. Does this mean I can connect the C-1 preamp to Main Amp Ins and only access the amp section of the 330B?
I want to use the 330B amp driven by my C-1 preamp.
Thanks in advance!
David
