Infinity Qe crossover

[Citizen Gain]

Hello all!

I'm building new cabinets for a pair of Infinity Qes I was given. Specs on the Infinity Qe can be found by following this link.

While I have the drivers and crossovers out of the old cabinets, before installing them in the new, should I replace the crossover? Build a new one perhaps? I have absolutely no experience in crossover construction, so if I should make one, then I'd need some recommendations.

Or should I leave well enough alone and use the stock crossover intact?

 

[Bauhausler]

Hello all!

I'm building new cabinets for a pair of Infinity Qes I was given. Specs on the Infinity Qe can be found by following this link.

While I have the drivers and crossovers out of the old cabinets, before installing them in the new, should I replace the crossover? Build a new one perhaps? I have absolutely no experience in crossover construction, so if I should make one, then I'd need some recommendations.

Or should I leave well enough alone and use the stock crossover intact?

I recently parted out a pair of Qe's. IIRC, the crossover is a small choke and a 9.5uf film cap. If there's no electrolytic cap in there I'd use it as is.