• Check out the Annual AK Secret Santa exchange Program, signup before November 23rd in the AK Charities & Christmas forum!

KLF-20 Project

Dudeman7

Well-Known Member
Picked up a pair of KLF-20s today. They are in pretty good shape overall but will need a few things to get them back to their former glory.

I am going to reglue the baffles since one is loose already and I assume the other isn't far behind. Probably going to get to that tomorrow.

I will also need to either source the jumper plates for one speaker that is missing them or else make up a couple jumpers with wire. If anyone knows where I might find two originals, that would be a big help.

Finally, the cabinets are a little rough, cosmetically. One is OK but the other one is pretty scuffed up and is missing a fair amount of black paint. For anyone who has ever refinished their black Klipsch speakers, what did you use? I have read that some people use matte black Rust-Oleum after a light sanding. Is that still good practice or should I try to find black lacquer or something?20260723_205922.jpg20260723_205903.jpg
20260723_205812.jpg
 
Register to hide this ad
I got these fixed up between last night and today. I reglued the baffles, sanded them smooth and gave them a couple coats of paint. I used satin black Rust-Oleum Door and Trim paint. It went on really smooth and covered well, but it still alllows the wood grain to be visible.

A pair of Crites Ti tweeter diaphragms should be here next week and I might use clay or Dynamat on the back of the horns while I'm in there.

They sound really good as-is but I expect the new tweeter diaphragms to clear up the high end a little more. I really like what Crites Ti diaphragms did for my KGs a few years ago.
 
Probably both horns. Some even do the metal parts of the speaker baskets, too.

Great! Thanks.

I did the midranges last night. Can't really say I noticed too much of a difference in how they sound but I figure it doesn't hurt anything. I'll do the tweeter horns when I have them out to swap diaphragms.

Really loving these speakers so far. They are my first large Klipsch and they are impressive, even with modest gear upstream.
 
So, I ended up pulling the tweeters out and adding Dynamat to the back of the horns tonight. After playing a couple albums, I can say that that seemed to focus the center of the soundstage noticeably. They sounded really good before but vocals (especially female), violins, upper register piano and acoustic guitars have a more airy, realistic quality than before.

Is it possible for the bare, undamped tweeter horns to be vibrating enough to audibly smear the high end that much? Seems to be the case. Still doesn't make much logical sense to me that adding Dynamat to the midrange horns didn't yield as noticeable an improvement.

I'm still planning on putting the Ti tweeter diaphragms in when they arrive and I'm super excited to hear what they do. Even with the stock, poly diaphragms, these KLFs are quite revealing. I can easily see them becoming gateway speakers that will prompt me into upgrading everything else in that system, just so I can get to the limit of the Klipsch's potential.
 
The Crites Ti diaphragms arrived today and I put them in a few hours ago. I've been listening to the speakers since and have to say, they made great sounding speakers sound even better. Gone are the harsh transients and rough, leading edges of note that I was getting at higher volumes with the stock, poly tweeters. Despite what one might think when discussing metal vs plastic diaphragms, the Crites' actually sound warmer and smoother than the poly ones. Cymbals bloom and wash into the room effortlessly and there is air and space around everything else. 100% recommended upgrade for these KLF-20s.

When I first got these speakers, I wasn't sure what to expect. They clearly needed a lot of work but since I got them for free, I figured I could sell them if they weren't to my liking and fund some other purchase. Also, I had read that people online loved them, especially once the common issues were addressed and upgrades were done. That gave me hope and the motivation to dig into them.

Now, I completely understand what people mean when they say that properly restored and upgraded KLF-20s compete with or best many speakers that cost significantly more than them. I am really looking forward to revisiting my music collection and seeing what these speakers can show me that some of my other speakers might not be able to.
 
That's awesome. I think I have the same Ti diagrams in my KG2.5, and your review sounds spor-on. Enjoy!

Thanks! Will do.

Funny enough, I also have a pair of KG-2.5s and I put Crites Ti diaphragms in those tweeters too. They were a noticeable improvement in those speakers and I would do it again in a second.

Part of me wants to try the KG-2.5s as rear channels with the KLF-20s as mains in my basement 5.1 setup. I feel like the clarity and detail retrieval from both sets of Klipsch would make for a very realistic sounding experience with movies and games. So far, I have only used either pair for 2-channel music listening and they both are exceptional sounding speakers, IMO.
 

Well, it took a lot of planning and rearranging multiple systems, but I ended up putting the KG-2.5s in the surround sound setup. They are the rear channel speakers and the KLF-20s are the fronts. I have a Polk center channel speaker that I will probably swap out for a suitable Klipsch.

After I got it all set up and ran YPAO on my Yamaha AVR, house guests arrived so I haven't had a chance to actually use it yet. Maybe tonight.
 
Definitely happy with this setup. The KLF-20s are great and the KG-2.5s mesh well with surround sound content. The Yamaha AVR always did a nice job of spacial positioning and these Klipsch speakers make the most of that.

That receiver has an "All Channel Stereo" setting that I checked out with the Klipsch speakers and a few CDs that I'm very familiar with. It is definitely a little different since I am sitting inside the stereo image/soundstage instead of it being in front of me as it is with just the KLF-20s. I found myself enjoying it much more than I thought I would! Again, the KLFs and KGs blended together well, complimenting each other instead of contrasting.

All in all, I'm quite pleased with how this all turned out. I can definitely recommend Klipsch KLF-20s, especially when the cabinets have been addressed and the couple simple modifications mentioned above have been done. Also, I can't say enough good things about the Crites Ti tweeter diaphragms. They sound wonderful, are reasonably priced and he shipped them out right away. Class act, that guy.
 
That's awesome. I don't have to room space to surround-sound my KG2.5's with the CF2's, but did pick up a half dozen Klipsch in-ceiling cans from the scrap bin at work. Those might get new boxes and ceiling mounted.

Great rig, you! Enjoy!

(KV-series center channels also work well with the Crites Ti diaphragm. Got that one working with my rig. Just sayin'.)
 
That's awesome. I don't have to room space to surround-sound my KG2.5's with the CF2's, but did pick up a half dozen Klipsch in-ceiling cans from the scrap bin at work. Those might get new boxes and ceiling mounted.

Great rig, you! Enjoy!

(KV-series center channels also work well with the Crites Ti diaphragm. Got that one working with my rig. Just sayin'.)

Cool! Sounds like those ceiling speakers might be a good project. Have you done anything with them yet?

I haven't looked too hard for a Klipsch center speaker yet but I'll put the KV on my list of possibilities. Thanks!
 
Nothing than hook up a pair to a 50w chip amp in the garage.
Found another one in the recycle bin at work today, that makes six total now. :-D
 
View attachment 3808640View attachment 3808641View attachment 3808643

These are some progress pics.

The Crites tweeter diaphragms should be here Thursday and I got more Dynamat today.

For those who have worked on these speakers, would you do Dynamat on the backs of both the tweeter and midrange horns?
I did all the upgrades to my KLF-30's and experimented with several tweaks. Dampening the horns had zero benefit. Gluing and bracing the cabs was the most necessary.
 
I did all the upgrades to my KLF-30's and experimented with several tweaks. Dampening the horns had zero benefit. Gluing and bracing the cabs was the most necessary.

Yeah, addressing the cabinets on my -20s was definitely the most important part. The Crites Ti tweeter diaphragms made a noticeable improvement, too.

As mentioned above, adding Dynamat to the midrange horns wasn't necessarily needed but the tweeter horns seemed to benefit from it. All in all, these were all pretty inexpensive things to do to an otherwise free pair of speakers. I would do the same things again if I ever got another pair of them.

I'd love to hear some KLF-30s like yours some day.
 
Nice! I'm picking up a set of KLF20's tomorrow, complete w/original boxes. One owner. All original. And got a set of brand-new TI diaphragms included. I didn't tear them down but gave everything a good wack with a rubber mallet. With KG's at least-it's very obvious when they have issues with this method. Seem solid.
A good deal-not cheap but they are mint shape.
 
Back
Top Bottom