• Check out the Annual AK Secret Santa exchange Program, signup before November 23rd in the AK Charities & Christmas forum!

Matching volume when auditioning multiple amps

itsikhefez

Active Member
Hey

How would I go about to match volume of 2 amps when auditioning side by side?
I don't want to have a perceived better experience because volume is louder.
I don't have a volume meter, was hoping to use an App that utilizes my iPhone mic and some test tone.

I was just wondering if anybody has done this before and has recommendations for either.
Thanks
 
Register to hide this ad
There are plenty of free apps that will do exactly what you want. Test tones are widely available on the web. A 1kHz signal is what many use for level matching.
 
There are SPL apps for any smart phone. They are not really that accurate, but for your purpose, you don't need an absolutely accurate number, just to get them to read the same/similar. Play the same track/test tone on each amp until you get them to match.
 
Listening does not require level matching. You need to spend time with the amp to LISTEN TO IT. Is it transparent? Does it kick. Does it have trouble with deep material? Is it quiet when you have the volume all the way down. are you hearing stuff you never heard before?
 
A good ac voltmeter while playing a test tone is more accurate than a smartphone app measuring db.



Listening does not require level matching. You need to spend time with the amp to LISTEN TO IT. Is it transparent? Does it kick. Does it have trouble with deep material? Is it quiet when you have the volume all the way down. are you hearing stuff you never heard before?

You might not need to level match to "listen", but definately do if you want to "compare".
The oldest audio salesman trick in the book was to compare amps with the one you want the customer to buy playing slightly louder. It will sound "meatier" than the slightly quieter amp.
 
The oldest audio salesman trick in the book was to compare amps with the one you want the customer to buy playing slightly louder. It will sound "meatier" than the slightly quieter amp.

Same thing with speakers--play different sets of speakers with different levels of efficiency--most people will always pick the louder ones.
 
How would I do this measurement?

Using a DMM set to AC voltage, use a test tone (typically 1KHz) and measure the AC voltage output at the speaker terminals; however, this is only valid if you are using the same preamp stage and same speakers attached. Different volume controls may not be as "linear" as others, so as you alter volume, their response will not be the same, and different speakers have different impedences at any given frequency, throwing another wrench into the equation. "Dummy loads" can be used if you want to get that picky.

IME, absolute specs from the manufacturer, from O-scopes, and DMMs are not the "end all--be all" in determining how an amp is going to "sound" in any given system. Some gear just does not "play well with others", and then some "unlikely bedfellows" play great together. Just LISTEN, LISTEN, LISTEN--after all, it only has to sound good to YOU!!!
 
I just run some pink noise and a RS db meter. However, you do need to compare at different levels as some amp/speaker combinations will provide a sound quality that is quite different at low, medium and high levels. You may prefer one amp at low levels and a different amp at high levels for example. Also, different amps my like unique speaker placement compared to others.
 
Back
Top Bottom