• Check out the Annual AK Secret Santa exchange Program, signup before November 23rd in the AK Charities & Christmas forum!

Nikko NA 890

philster

Active Member
I just got this Nikko NA 890 for a great price. Cleaned it up , cleaned the pots and switches. Hooked it up to test it and no balance control. Sounds great except no balance. Pulled the case off again to check solder connection on the balance pot and just another visual and as I was following the traces from the pot I find 2 resistors soldered to the back of the board in the circuit going to the balance pot. Any idea why, possibly bypassed? Pic attached.15996668453342903247076531715681.jpg
 
Register to hide this ad
I'm guessing either the pot was bad or previous owner thought that it detracted from the sound.
Thinking the same. Measured resistance on the pot. .5 ohms to either side. Resistors measure .25 . Wondering if I pulled the resistors and tested it if it would affect anything in a bad way. If you notice in the second pic there is an empty soldering pad as well. The board s on these are nicely labeled so going to pull the top to see what goes there
 
Um - those resistor bands looks like 1 meg to me. My guess it is to prevent popping or static in some ungrounded cap or component... Don't see how it could be for a bad control.
 
Um - those resistor bands looks like 1 meg to me. My guess it is to prevent popping or static in some ungrounded cap or component... Don't see how it could be for a bad control.
Measuring resistance in-circuit is not a reliable way of doing so, neither for the pot nor the fixed resistors, since you're measuring the resistance of the entire circuit at that point.

Volume pots are usually in the thousands of ohms.
 
Yeah I know in circuit testing for resistance is not reliable but what it told me was the Balance pot was working fine showing resistance across both sides. I pulled the resistors and they measured 1 meg as the bands indicate. According to the schematic the balance pot is supposed to be 250k ohm. At any rate that fixed the balance pot issue and it sounds a little bit cleaner. My first Nikko unit and color me impressed. A lot more power than my Kenwood KA-5700 and crisper.
 
hi @philster I have an NA-890. The solder side of the board has quite a few things tacked on. I believe that the additions are all factory as I was not able to see evidence of any work being done inside the amp. This is speculation on my part. The balance control does work on my copy of the amp.

Does your NA-890 have the some or all of the components shown in my pic?
Do the resistors that you removed from your amp appear to be in the same locations as any of those in my pic?


<sorry for poor pic quality...it is the best I have and the amp is not here at the moment>
DSCN0014rs900.JPG
 
Last edited:
hi @philster I have an NA-890. The solder side of the board has quite a few things tacked on. I believe that the additions are all factory as I was not able to see evidence of any work being done inside the amp. This is speculation on my part. The balance control does work on my copy of the amp.

Does your NA-890 have the some or all of the components shown in my pic?
Do the resistors that you removed from your amp appear to be in the same locations as any of those in my pic?


<sorry for poor pic quality...it is the best I have and the amp is not here at the moment>
View attachment 1976420
Nope, not even close. My balance pot did not work prior to me pulling the resistors. I had audio out of both channels evenly but wasn't the best in my opinion. You could tell the resistors were put in by a novice because of the horrible solder job. After pulling the resistors I have balance control and it sounds much cleaner. Nice amp and we'll built.
As for other components on the solder side I don't have that. I will upload a pic this weekend while I am recapping it.
 
Back
Top Bottom