Ready for cap replacement but...

[artie in mia]

I cannot find a source for caps that show what I need...I have a fisher 505t and I need the caps that have 2 wires coming from the positive end and the can grounded...what are these called ? The first 2 are 2000 uf and 50 vdc...I read someplace that if you cannot find the correct voltage that you can get caps w/ higher voltage ? I have everything ready to go, just need the caps...where to look ?

thanks
artie

 

[Baron K Rool]

Higher voltage rating is fine.

Higher capacitance is, too. At least in this case. 2000µF is not a standard value - you will not find that anywhere.

Go with a 2200, 3300 or 4700µF capacitor instead. Minimum 50V (but 63V or 100V will be fine, as well).

 

[artie in mia]

dual output ?

Can I replace the dual output can caps with 2 single output...what if the leads won't reach the holes in the board ?

artie

 

[avionic]

I cannot find a source for caps that show what I need...I have a fisher 505t and I need the caps that have 2 wires coming from the positive end and the can grounded...what are these called ? The first 2 are 2000 uf and 50 vdc...I read someplace that if you cannot find the correct voltage that you can get caps w/ higher voltage ? I have everything ready to go, just need the caps...where to look ?

thanks
artie

Axial or radial leads ?

 

[artie in mia]

cap leads

axial leads...two leads coming from one end (dual output) and the can is grounded.

artie