• The move to the new server is done. There are some software and database maintenance updates in process. This has us passing the hat around to help out. We appreciate any donations. Seriously, even a dollar helps. The payment page may be found here - https://www.audiokarma.org/support.html

Replacing power cord's on vintage gear

MikeCh

MikeCh

Super Member
Is it ok to use a polarized (plug) power cord to replace a non-polarized (plug) OEM cord of the same gauge/jacket thickness, etc. ? If so, are there any particulars for soldering these to the correct terminals inside the gear? The amp and tuner that need them are Kenwood KA-7002 and KT-7001.

Thanks,
Mike
 
Register to hide this ad
IMO, since the original cord is non-polarized then orientation of the replacement cord is not critical, however, since you will be inside the equipment anyway, It would not hurt to connect the hot side (narrow blade) to the switch side in the equipment.
 
You must log in or register to reply here.
Back
Top Bottom