• Check out the Annual AK Secret Santa exchange Program, signup before November 23rd in the AK Charities & Christmas forum!

Sansui 4000 recap question

sanjib

AK Subscriber
Subscriber
Hi
I am planning to do a recap of my Sansui 4000. I am planning to do a full recap of the driver board and change only 2SC458 transistors. for tone board all electrolytics and small-signal transistors and same for equalizer board.
I also want to recap the protector board F1176 and change the 2SC458 there. My question is if I recap this board do I need to do "Protector Adjustment" following the procedure in the service manual?

Thanks
 
Register to hide this ad
My question is if I recap this board do I need to do "Protector Adjustment" following the procedure in the service manual?
Whenever you change that many components around a unit you should always verify that the protection circuit works. The reason being, and especially if you change components directly involved in such circuitry how will you know if it works afterwards?
 
Whenever you change that many components around a unit you should always verify that the protection circuit works. The reason being, and especially if you change components directly involved in such circuitry how will you know if it works afterwards?
Thanks!
 
Back
Top Bottom