SD-1100 Scope used by Bob Carver in Lab?

[madpioneer]

WOW! Love these to begin with but to have one that was actually used at Phase Linear. :yes:
Look Here!

 

[siamac]

That one is very nice with a nice story too.
I´m waiting for my SD-1000 arriving this week.

 

[siamac]

Sd-100

This Scope Display is called SD-100 and is the 100Volt Japan Version of the SD-1000!
I would love to get more Information about this displays :scratch2:

 

[siamac]

The Horiz VU-Meter is not working.

I ordered a service manual at agtannenbaum.com .

I think the SD-1100 is much easier to use, because is has chinch-jacks instead of just banana-jacks.

 

[siamac]

$ 500 was to much, now he started with $ 300,-

http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=5799756767

 

[siamac]

:thmbsp: :yes: Service Manual arrived today, everything is working :yes:

 

[Trawlerman]

Thanks for sharing that SIAMAC. Always wanted to see one up close

 

[Pioneer727]

Is it a single trace scope? I used my B+K 1522 dual trace scope in X-Y mode for the light show but the problem is between songs you get a single brite dot that can cause burn in so I did not have it on for long.But what a show. :yes:

Ron

 

[packrat]

:thmbsp: :yes: Service Manual arrived today, everything is working :yes:

Nice setup! What amp is it sitting on (I'm guessing an SA-1000)? I have a tuner that has the same knobs - TX-1000.

 

[Sandy G]

"There is nothing wrong with your television set. We are controlling transmission...." <grin>-Sandy G.

 

[siamac]

Nice setup! What amp is it sitting on (I'm guessing an SA-1000)? I have a tuner that has the same knobs - TX-1000.

Yes it is an SA-1000, good working, but the power light don´t want to shine??
The power light from the SA-800 below is working. I changed them - but it doesn´t want to burn in the SA-1000?