Honorable mention for bringing one back to life?
Here's my SH9010 PEQ ...
Broken slider and I did lose a light after taking this pic, but I was able to scroe ... er ... score ... replacement parts off AK ... Thanx Ben! (aka ev13wt) for service beyond the call ...
Tricky lil deveel to replace - let's all have a hearty rass berry for engineers who insist on chaining switches instead of good old fashioned point to point wiring. I suppose it makes perfect sense during the original build.
There was enough slack to put a small bend in the end where I clipped the old switch out so there's a good solder blob for strength when the new one went in. Lights were exact replacement and went in easily.
Scariest part of the job was the thought of bumping any of the controls and throwing off the settings. I'd managed to reach nirvana courtesy of REW software, calibrated mikes and such, and didn't want to screw that up. Took copious notes and pictures of the control positions prior to diving in and got lucky. Sounds truly excellent.
PS ... while I was at it, I'd had the top cover on in side out because of some surface rust. Went over it very carefully with a 00 polishing pad so as not to disturb the diagrams. Got the rough stuff off, then did a few coats of black shoe polish to bring back the shine. Turned out real decent - next best thing to factory fresh.
Not sure how long it'll hold up, but shoe polish is cheap ...
~~~
Oh. Almost forgot ...
